How to save money on your well

Before you can get your building permit you have to have three things. 1) Electricity, 2) Running Water and 3) Septic. We took care of electricity a few weeks ago and the septic system has been designed, happily we celebrated today with water. Yep, that's right ... good, clean, cold water right out of the ground. We had a professional drill the well as they don't exactly rent out well-drilling rigs to novices. He hit water at 15 feet and dropped the casing down to 90 feet. When you start sucking water out it draws down, but it steadies at a certain level (which for us is at 40 feet) so this set-up will ensure we never are without water.

One of the biggest ways we saved money with our well was to do the trenching and installation of the pump ourselves. For those who don't know, the well head is just a piece of pipe sticking out of the ground. There is water pipe and power running underground from your well head to your control box and then from your control box to your power source. As Mr. Nick is an expert trencher (ref: Conduit Loop Line) this was not a big deal for us.

Here is our well-head. Notice the pitless adaptor at the bottom and the

The other way we saved money is by installing all the components of the well ourselves. You have to have some knowledge of electrical and some knowledge of plumbing to make this happen but for us we were able to make it work.

These components included:

•Pitless Adaptor •Pipe •Electrical •Pressure Tank •Pump •Control Box